problem 147
-
milan-marko
- Garaža: 156 mjet 2005
- Lokacija: Beograd-Zarkovo
- Lokacija: beograd
Post
problem 147
zlikovci mi sinoc na vozacevoj strani,gurnuli srafciger u cilindar i razvalili ga,nisu nista hvala bogu uzeli iz auta...ali je sada auto na izvolte...moze da se gurne bilo koji kljuc i da se otkljuca auto...da li neko zna kako se skida cela kvaka ili samo cilindar i gde da nabavim novi ili eventualno slepi...
-
milan-marko
- Garaža: 156 mjet 2005
- Lokacija: Beograd-Zarkovo
- Lokacija: beograd
-
gilegi
- Drug Član
Post
Re: problem 147
A da kažeš za početak odakle si, pomoglo bi da ti pomognemo? Ima ona kućica u profilu "Lokacija", nije džabe tamo...
-
Dragon
- Saradnik Uprave
- Garaža: Giulietta 1.4 Distinctive
ex GTV Cup 2.0 TS
ex 156 JTD SP
ex 147 2.0 TS
ex147 1.9JTDm - Lokacija: Beograd
- Lokacija: Beograd
Post
Re: problem 147
Nasao sam nesto na engleskom.
REMOVING THE EXTERNAL HANDLE
10) Pull the weather seal panel gently away from the top right quadrant of the door panel to allow access to the forward retaining bolt of the external door handle. The remainder of the membrane can remain attached. Pull the membrane out of the way and secure loosely using masking tape.
11) Release the handle’s forward retaining bolt with a 10mm socket or spanner by either i) accessing it through hole 'A' shown in (FIG x) or by reaching through the larger hole 'B' to the left. Note: Take care not to drop the nut into the door body.
12) Remove the second bolt on the end of the door using a Philips screwdriver.
The handle is now unsecured but is still attached to the two stays which operate the door opening mechanism and the lock.
REMOVING THE EXTERNAL HANDLE
10) Pull the weather seal panel gently away from the top right quadrant of the door panel to allow access to the forward retaining bolt of the external door handle. The remainder of the membrane can remain attached. Pull the membrane out of the way and secure loosely using masking tape.
11) Release the handle’s forward retaining bolt with a 10mm socket or spanner by either i) accessing it through hole 'A' shown in (FIG x) or by reaching through the larger hole 'B' to the left. Note: Take care not to drop the nut into the door body.
12) Remove the second bolt on the end of the door using a Philips screwdriver.
The handle is now unsecured but is still attached to the two stays which operate the door opening mechanism and the lock.
John Lennon - 2600 Sprint, SS, Pope John Paul II - Sei (Alfa 6), Sophia Loren - Duetto, Frank Zappa - 1969 GTV, Ralph Lauren - 8C2900B, Nick Mason - TZ-1, John F. Kennedy - Giulietta Spider, Eric Clapton - 6C 2500 Super Sport, Dragon - GTV Cup.